In an outboard motor, two things need watching: For an outboard motor, the temperature of concern is different from the that in the motor installed in your car. On an outboard, the temperature of the cylinder head needs to be monitored, not the temperature of the cooling water. Yamaha outboards are cooled by raw water, with a bypass valve that opens when the cylinder head reaches a preset temperature. There's an accommodation for an analog sensor -- a boss in the top of the No. For determining the engine speed, a component called a "tachometer" only needs two connected wires.
Kubota Tractors Discussion Forum Archived Messages
Harley Davidson Motorcycle Parts & Motorcycle Accessories | Motorcycle Parts for Sale
The oil temperature gauge monitors transmission oil temperatures and warns you before the oil get too hot. If the oil temperature gets too hot it can mess up your transmission fluid or possibly cause engine damage. The normal temperature should be between degrees F and degrees F. The oil temperature gauge works with all 12 volt negative ground systems.
Fastening & Joining
Modifications How to install an oil temperature gauge The working temperature of your engine is normally kept to an optimum level by the cooling system. But there are occasions when your engine is worked harder and reaches temperatures higher than normal. This can happen, for example, when you are towing a trailer or another vehicle, or if your engine has been tuned for higher performance. Oil gauge kit Oil gauge kit Oil temperature gauges can either be mechanical or electrical. Below is an example of each type of kit.
How to Install an Oil Pressure Gauge by William Zane An oil pressure gauge can be a crucial device for monitoring the health of your engine. The gauge is a simple device that reads the pressure being produced by the engine's oil supply via a thin tube that the oil runs through. An oil pressure gauge can be a good indicator of your engine's health, alerting you if there are any problems with the engine's oil supply. Slide the end of the clear oil line into the fitting on the back of the oil pressure gauge, tightening the fitting onto the line with an open-ended wrench.